ActSafe PME Bedienungsanleitung PDF herunterladen (Seite 19)

User’s Manual PME Ascender 4-stroke engine

USAGE

Ascent

1. Place the ascender on the ground.

2. Turn the main switch on.

3. Press the priming bulb several times

until fuel can be seen (hidden).

4. Use the choke if needed (cold engine).

5. Pull the starter (hidden).

6. Turn the accelerator handle towards you

to increase the speed.

7. Hold the handle  rmly in the right hand

with the ascender pointing towards the

right.

So that the exhaust fumes will blow away

from the user.

8. Feed away the “dead rope” during

the rst few meters of ascent.

After approx 5 meters the weight of the rope

will be suﬃ cient to “clean” the ascender from

itself.

9. Stop the motion by turning the handle

away from you or let it go, then slide the

ignition switch to the STOP position.

Always make sure that the rope feeds

smoothly. During ascent make sure the

outgoing rope is not blocked in any way.

Do not hold the rope just above the winch,

there is a risk of being pinched.

CAUTION

Adjust the speed according to the circumstances,

be aware and use common sense.

If balance is needed, hold on to the primary

connection sling or karabiner.

Turn the choke oﬀ as soon as the engine starts to

ignite.

Slowly pull the starter until you feel resistance.

Then pull the starter strongly in order to avoid

backstroke and injuries to hand or arm.

Stand straight beneath the anchor point in order

to avoid a pendulum movement when starting

oﬀ the ground.

RECOMMENDATION

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Keine Kommentare

ActSafe PME Bedienungsanleitung Seite 19