ActSafe PME Bedienungsanleitung PDF herunterladen (Seite 18)

USAGE

Connect to rope

1. Place the ascender on the ground.

2. Open the rope cover.

4. Put the rope around the rope grab.

5. Close the rope cover.

3. Form a loop on the rope and

push it through the rope guide

just above the rope grab.

6. Connect the primary connection

karabiner to the EN 813 connection

point of the full body harness and

check the karabiner is locked.

Check that the live rope exits to the left

and that the rope cover is fully closed.

Attaching the rope incorrectly can result

in serious injury or death. Always use the

ascender with a backup rope system.

Make sure that the rope is attached correctly

before use.

DANGER

Be careful handling the ascender with the

engine running - there is a risk of accidental

lifting without being properly attached.

If the ascender is connected to the rope and not

the operator; pay attention starting the engine

as it can accidentally ascend a short distance on

the rope before the engine is warm.

Drive the ascender to waist level to simplify

connection to harness.

RECOMMENDATION

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Keine Kommentare

ActSafe PME Bedienungsanleitung Seite 18