ActSafe PME Betriebsanweisung PDF herunterladen (Seite 22)

SERVICE AND DAILY INSPECTIONS

The machine has to be maintained and serviced according

to below instruction in order to ensure its reliable

functioning. ActSafe PME

must be sent to a competent

workshop at least once a year. Contact Act Safe Systems

AB for information about your nearest workshop

CARBURETTOR SETTINGS

Always use lead-free fuel with a minimum of 95 octanes.

- The T-screw should be adjusted to keep the rope grab

from turning during engine idle. The engine will have to be

adjusted for changes in temperature and altitude.

Ambient Temperature

SAE 10W-30 is recommended for general use. Other

viscosities shown in the chart may be used when the

average temperature in your area is within the indicated

range

AIR FILTER

The air filter must be cleaned from dust and dirt in order to

avoid:

- carburettor malfunctions

- starting problems

- engine power reduction

- unnecessary wear on the engine parts.

- abnormal fuel consumption

Clean the air filter daily or more often if working in

exceptionally dusty areas.

Cleaning the air filter:

Remove the air filter cover and the filter. Rinse it in warm

soapsuds. Check that the filter is dry before re-assemblage.

An air filter that has been used for some time cannot be

cleaned completely. Therefore, it must regularly be replaced.

A damaged filter must always be replaced.

TROUBLESHOOTING

Engine does not start

- Check the fuel (correct amount - or water in the

fuel?).

- Is the ignition cable attached to the spark plug?

- Is the setting of the adjustment lever ok?

Engine smokes

- Check the fuel tank gap for air openings

Engine runs for a short time and stops then

- Fuel level check.

- Check the fuel tank gap for air openings.

Oil Level check

Check the engine oil level before each use, or every

10 hours if operated continuously.

Check the engine oil level with the engine stopped

and in a level position.

Oil Change

Drain the used oil when the engine is warm. Warm oil

drains quickly and completely.

1. Check that the fuel filler cap is tightened securely.

2. Place a suitable container below the engine to catch the

used oil.

3. Remove the oil filter cap/dipstick and drain the oil into

the container by tipping the engine toward the oil filter

neck.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

ActSafe PME Betriebsanweisung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motor ActSafe PME